HEMERA HOT END SOFTWARE
This Marlin software is some pretty cool stuff. Even sadder, I had trouble recalling the word “meter” too. In fact, it took me thinking of the word “meter” to recall the word “calibrate” when I was writing this post. At 60, my memory is starting to cloud easily. When I’m done I’ll put that all in this thread. I’ve since added what I could find for the Extruder/Hotend, and I ran the temps up to low values just to ensure it was heating, and make the new E0 fan start up.Įvery step I’ve done since downloading the very first piece of software, I’ve documented in text with comments on what I understand. I’ve got a little more work to make it probe the bed in the right places, but I’ve got notes for that. It took 2 days to get it to the point it would Z_HOME in the center of the bed. I started with the E5 base example, and added the BLTouch. So I’ve been stitching it together in steps. Even less for the Marlin version of the firmware. In fact, there are only a few with any two of them. The biggest problem I’ve found so far is there is no single post or YouTube that has these five things: Ender 5, SKR Mini E3 V2.0 motherboard, TFT 43 V3.0 touch screen, Hemera Extruder/Hotend, and a BLTouch probe. I see an error in the information window, but I found something on Reddit that makes me think it will be dealt with when I get some values from the calibrations, that need to be added to the firmware and flashed to the printer. Now I’ve got a good base to work from so I can start the calibrations required. Took a couple days, but I got the configuration files edited and the firmware compiled and installed.
0 kommentar(er)
